|
Featured Site
|
|
NetworkCerts.com
Exam Prep 3 for Cisco CCNA Certification
Answer Key
1. What is the command to
enable IGRP for autonomous-system 10?
|
|
router
igrp 10
|
| 2. What
command would you use toverify connectivity to 172.16.12.12? |
|
ping
172.16.12.12
|
| 3. What
command would you use to disable access-list 5? |
|
no
access-list 5
|
| 4. Type in
the access-list command to deny all traffic from the 172.16.12.0
network (use 5 for the access-list number). |
|
access-list
5 deny 172.16.12.0 0.0.0.255
|
| 5. Type in
the command to view all routers your data must pass through to get to
ip address 172.16.12.12. |
|
traceroute
172.16.12.12
|
| 6. What
command would be use to designate the description for an interface as
"T1 to Tokyo Office". |
|
description
T1 to Tokyo Office
|
| 7. What is
the command to enter configuration mode for interface serial1? |
|
interface
serial1
|
| 8. What
command would you use to view the configuration stored in NVRAM? |
|
show
startup-config
|
| 9. What
command would you use to set the LMI type to ansi for frame relay? |
|
frame-relay
lmi-type ansi
|
|
10. What
command would you use to view all ipx routes?
show
ipx route
|
"Cisco"
the "Cisco Logo", "CCNA," "CCNP," "CCDP,"
"CCDA," "CCIE,"
"Cisco Certified Network Associate," "Cisco Certified Design
Professional," "Cisco Certified Design Associate," and
"Cisco Certified Network Professional," are registered trademarks
of Cisco Systems Inc. This site and the contents contained herein, is not
associated with or endorsed by Cisco Systems, Inc.
|
Featured
Book
|
