Free Practice Exams & Studyguides By NetworkCerts!!

	Sign In Sign-Up

Advertising Inquiries CLICK HERE

Featured Site

NetworkCerts.com Routing Practice Test 12 For Cisco's CCNP/CCDP Certification
Answer Key

1. What is the command to enable IGRP for autonomous-system 10?
router igrp 10
2. What command would you use toverify connectivity to 172.16.12.12?
ping 172.16.12.12
3. What command would you use to disable access-list 5?
no access-list 5
4. Type in the access-list command to deny all traffic from the 172.16.12.0 network (use 5 for the access-list number).
access-list 5 deny 172.16.12.0 0.0.0.255
5. Type in the command to view all routers your data must pass through to get to ip address 172.16.12.12.
traceroute 172.16.12.12
6. What command would be use to designate the description for an interface as "T1 to Tokyo Office".
description T1 to Tokyo Office
7. What is the command to enter configuration mode for interface serial1?
interface serial1
8. What command would you use to view the configuration stored in NVRAM?
show startup-config
9. What command would you use to set the LMI type to ansi for frame relay?
frame-relay lmi-type ansi
10. What command would you use to view all ipx routes? show ipx route

Featured Book

"Cisco" the "Cisco Logo", "CCNA," "CCNP," "CCDP," "CCDA," "CCIE,"
"Cisco Certified Network Associate," "Cisco Certified Design Professional," "Cisco Certified Design Associate," and "Cisco Certified Network Professional," are registered trademarks of Cisco Systems Inc. This site and the contents contained herein, is not associated with or endorsed by Cisco Systems, Inc.